13
OPERATION
13.1
operating instructions
Perform all conversion work only in isolation from electric power
network by!
CAUTION when cutting long workpieces without trestle!
Property damage and injury by shooting up the workpiece possible!
Therefore: long, protruding workpieces must be supported
13.2 Operation
13.2.1 Maschine Starten / Stoppen
If you want to press the ON - OFF switch, the
combined EMERGENCY STOP switch must be lifted in
the open state.
To start, press the green button ˝ I ˝
To stop, press the red button ˝ O ˝
INFO: In the closed state of the main switch can be operated as an EMERGENCY STOP switch.
Important:
Do not start the machine until completely for maximum speed before you start
sawing.
13.3
Settings
13.3.1 Setting the table tilt
Clamping lever
The clamping lever under the table top to the base console loosen.
Rotate the table to the desired angle of inclination.
HOLZMANN MASCHINEN GmbH www.holzmann-maschinen.at
W A R N I N G
D A N G E R
OPERATION
35
HBS 400