Fitting The Cross Actuation Device - Truma Mover SR Gebrauchs- Und Einbauanweisung

b
Figure 24
Position the drive rollers in such a way that they are roughly at
wheel hub height / middle of the wheel.
Figure 25
In the event of a deviation, Truma can provide 30 mm and 60 mm
spacer sets as accessories in order to compensate for this.
Spacer set 30 mm, part no. 60030-95000,
Spacer set 60 mm, part no. 60030-95100,
Make sure that there is adequate ground clearance (at least
110 mm).
Set the correct distance between tyres and rollers (20 mm) with
the spacer gauge provided by moving the drive assemblies (in
the disengaged position) in the longitudinal direction. The mov-
able connection pipe makes it possible to adjust to the frame
width.
20 mm
Figure 26
Move the drive assemblies in a lateral direction in such a
way that as much of the tread area of the tyre as possible is
covered.
Ensure that there is an adequate distance between the gear-
box and the tyres / shock absorbers so that they do not come
into contact.
The minimum distance with the drive rollers engaged is
10 mm.
22
Figure 27
Once the drive assemblies have been correctly positioned,
tighten the bolts (c) of the mounting set a little, then check the
required distances again. The weight of the caravan must be
resting on the wheels when doing this.
Place the movable connection pipe in the centre (use the mark-
ing) and fix each side with 2 threaded bolts (g) M8 x 12 (15 Nm).
Re-check the distance of 20 mm from the tyre (with the
wheels under load). Then tighten the 2 bolts of the mounting
set (M10) alternately to 25 Nm.
min. 110 mm
Figure 28

Fitting the cross actuation device

Make sure that the drive rollers are not engaged (on both sides).
Push the connection pipe (1) into the central pipe (2) with the
holes facing outwards.
Push the connection pipe (1) onto the deflexion bolts (a). Push
the bolts (5) through the deflexion bolts and tighten.
Centre the central pipe (2), measuring again if necessary. In
this position, tighten the 2 threaded bolts (3 + 4) (15 Nm). Fi-
nally, check all the bolted connections again.
min. 110 mm
Figure 29
Engage the rollers using the lever provided. The drive rollers
should now be engaged on both sides. Check the opposite
side as well. Disengage the drive rollers again.
Repeat this procedure on the opposite side.
The threaded bolts are coated with sealant, and must
therefore only be bolted in once.
The bolts are coated with sealant, and must therefore
only be bolted in once.
5
3
1
a 5
min.
10 mm
25 Nm
4
2