Herunterladen Diese Seite drucken

Function Check; Warnings - Truma Mover SR Gebrauchs- Und Einbauanweisung

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 3
Connect fuse in the positive lead (150 A) near the positive
terminal.

Function check

Check whether the battery is fully charged for operating the
Mover®.
Position the caravan on open, level ground and apply the
parking brake. The drive rollers must not be in contact with
the wheels and the corner jacks must be raised.
Connect the battery terminals to the battery. Check that all
cables are securely attached and not hot, and that there are
no signs of short circuits etc.
Move slide switch on remote control to the "On" 
switches on the remote control, and the green LED flashes in
combination with the audio signal for approx. 5 seconds until
the control unit is ready for use. If LED does not illuminate,
check polarity and condition of batteries in remote hand set.
The remote control switches itself off after about 2 minutes if
no buttons are pressed.
Check that neither drive motor is running. With the remote
control switched on at a distance of no more than 2 m from
the control unit, press the "Forwards" button. Both drive
motors should now move forwards.
Move the slide switch on the remote control to the "Off"
position to switch off the remote control and therefore the
Mover®.
Engage the drive rollers using the lever provided. Turn the
lever until it locks into position mechanically and can no
longer be turned without excessive force (the end position is
roughly vertical).
Ensure that there no obstacles around the caravan, release
the handbrake and switch on the remote control. Now check
all functions several times in accordance with the operating
instructions.
Apply caravan parking brake. Move the slide switch on the re-
mote control to the "Off"
control and the Mover. Release the drive rollers using the lever
and check the distance between the rollers and tyres again.
Re-adjust if necessary.
The distance between the disengaged drive rollers
and tyres is 20 mm.

Warnings

The installer or vehicle owner must apply the yellow sticker
with the warning information, which is enclosed with the ap-
pliance, in a location in the vehicle where it is clearly visible
to all users (e.g. the wardrobe door). Missing stickers can be
requested from Truma.
24
position. This
position to switch off the remote

Quicklinks ausblenden:

Werbung

loading