Fitting The Drive Elements - Truma Mover XT4 Gebrauchsanweisung, Einbauanweisung

Adapting the mud guards to the Mover®
1. Remove the mud guards.
2. Fit Mover® in accordance with the following installation
instructions.
3. Determine dimensions a and b and transfer to mud guards.
The top leg of the fastening bracket must face towards the
rear of the caravan.
Determining the cut-out sizes
Mover® XT4
a
b
Figure 15
Cut out the template at the end of the installation instructions,
place onto mud guard, transfer contour and cut out (figure 6).
Pay attention to left and right sides!
If necessary, make recesses in the mud guard for the apron
contour. Secure the mud guard 300 mm from the tyre on the
underside of the caravan.

Fitting the drive elements

The frame of the vehicle must be free of rust, grease and
heavy soiling. There must be no damage in the area of the
wheel suspension.
The wheels and tyres fitted on the caravan must be of the
same size and type, and must be inflated in accordance with
manufacturer's instructions.
Remove all components from packing and place on the floor.
Figure 16
In order to guarantee the validity of the general operat-
ing permit (ABE), the type plates(f) must be present on
the cross-struts (4 x).
a
Mover® Mover® XT / XT2 XT / X X XT2
b
Figure 17
Mark the connection pipes in the centre. Loosely connect the
drive assemblies with connection pipes.
Do not screw in the supplied threaded bolts (g) yet.
Figure 18
Place the drive assemblies with the connection pipe and
mounting kit (b) on the vehicle frame and bolt them on with
the two bolts (c) in such a way that it is just possible to move
them along the frame.
The gripper (a) must be lying flat against the chassis
frame (e) in its entirety and also flat against the leg (d).
Figure 19
b
Figure 20
If the frame is not high enough, Truma can provide 30 mm
and 60 mm spacer sets as accessories in order to compen-
sate for this.
Spacer kit 30 mm, part no. 60030-95000,
Spacer kit 60 mm, part no. 60030-95100,
f f
g
d
e
c
a
b
25