Assembling The Processing Tools; Operating The Appliance - Gastroback 40969 DESIGN ADVANCED Bedienungsanleitung

bowl fitting and is locked in position (picture B).
NOTE: Use the provided bowl only.

ASSEMBLING THE PROCESSING TOOLS

Take the processing tool you want to use into your right hand.
On the top of the attachment of the processing tool is a canne-
lure (picture C).
The motor head drive has a matching guiding pin (picture D).
Slide the attachment of the processing tool over the drive of the
motor head (picture E). Ensure the guiding pin slides through the
cannelure of the attachment of the processing tool.
Push the processing tool upwards until the metal spiral compres-
ses and you are able to turn the processing tool anticlockwise
(picture F).
The processing tool is properly assembled when the guiding pin
is locked in position (picture G).

OPERATING THE APPLIANCE

Place the food into the bowl.
Grab hold of the motor head in front of the processing tool with
your left hand and rise the motor head slightly upwards.
Note:
When the motor head is locked in position the head release
lever is locked as well. To release the head release lever slight-
ly rise the motor head.
Push the head release lever (picture H) with your right hand
upwards. The motor head is now released and you can lower it
carefully.
Note:
Do not drop the motor head. The motor head is very heavy and
the pivoted joint would get damaged if the motor head falls
down with active force.
Attach the splash guard to the top of the bowl, connect the power
cord to the outlet and turn the appliance ›On‹. Select a slow speed to start with and
slowly arise the speed level until reaching the desired speed.
44
B
tighten
Cannelure of
the processing
tool
C
D
Guiding pin of
the motor head
drive
E
F