Important Safeguards For All Electrical Appliances - Gastroback 40969 DESIGN ADVANCED Bedienungsanleitung

cannot reach it.
• Operate the appliance on a well accessible, stable, level, dry, and suitable lar-
ge table or counter. Do not place the appliance or any part of it on or near hot
surfaces (heater, gas burner, grill or oven). Do not process hot food. Wait for
the food to cool down. The rising steam and condensation on the appliance can
damage the appliance. Do not place the appliance near the edge of the table
or counter or on inclined or wet surfaces or where it can fall. Always unplug the
appliance when not in use. Place the appliance on a stable and level surface.
• Do not immerse the appliance or power cord in water or any other liquid. Do
not pour or drip any liquids on the motor head or power cord. When liquids are
spilled on the motor head, immediately unplug the appliance and dry the motor
head to avoid risk of electric shock or fire. Do not attempt to operate the appli-
ance, when liquids are on or in the motor head. With the appliance connected
to the power supply, do not touch the appliance with wet hands or when the
appliance is damp or wet or is touching wet surfaces. In this case immediately
unplug the power cord from the power supply and dry the appliance (see ›Care
and Cleaning‹).
• Do not place the appliance, accessories or power cord in an automatic dish-
washer!
• To avoid damage, do not use any abrasive cleaners, corrosive chemicals (i.e. dis-
infectants, bleach) or cleaning pads for cleaning. Do not use any hard or sharp
utensils for operation or cleaning. Keep the appliance away from sharp edges.
Do not leave any food dry on the surfaces of the appliance.
• The appliance is intended for blending and mixing food only. Do not use the
appliance for any other purpose, especially, do not process any liquids contai-
ning inflammable or corrosive solvents (i.e. paint or lacquer). Fumes of volatile
solvents coming in contact with the motor, could catch fire and explode!

IMPORTANT SAFEGUARDS FOR ALL ELECTRICAL APPLIANCES

• Ensure that the voltage rating of your mains power supply corresponds to the vol-
tage requirements of the appliance (220/240 V, 50 Hz, AC). Always connect the
appliance directly to a mains power supply wall socket with protective conductor
(earth/ground) connected properly. The installation of a residual current safety
switch with a maximum rated residual operating current of 30 mA in the supp-
lying electrical circuit is recommended. If in doubt, contact your local electrician
for further information. Do not use any multiple desk socket.
• Do not leave the appliance unattended while connected to the power supply.
Always switch ›Off‹ the appliance and immediately unplug the appliance after
operation and if it is not in use, cleaning and/or assembling or disassembling
the processing tools. Always grasp the plug to disconnect the appliance from the
power outlet.
39