Changing The Device Name (Name) - Conrad GKA100 Bedienungsanleitung

Testing phone number
You may use the following command to verify the phone number stored in the car alarm system:
TEST TEL #1513

Always enter the complete phone number in international format (including country
code), e.g. +49... for Germany. The text message commands (TEL1, TEL2,
TEL3,...) change only the phone number of the corresponding memory. The
numbers of the other memory are retained.

12.1.3 Changing the Device Name (Name)

If several products are operated at the same time, it is recommended to assign a different name
to each device. This makes it possible to assign alarm messages to the correct device.
To change the name at your device, send the following text message command:
SET NAME <new name> #1513
Example: Renaming the car alarm system to „NEWNAME":
SET NAME NEWNAME #1513
The confirmation text message looks as follows:
NEWNAME 1.xx
.......................
...
...

The device name has a maximum length of 16 characters.
Resetting to factory settings is possible with the following command:
RESET NAME #1513
94