Conrad GKA100 Bedienungsanleitung Seite 75

RF status LED (4):
This LED shows whether the RF recipient of the wireless remote control has received a signal
from a valid remote control.
Observe that only correctly coupled remote controls are recognised and displayed. How to
couple a remote control can be taken from the corresponding chapter.
The LED has the following display information accordingly:
• LED flashes red: Signal received by valid remote control
• LED off: Waiting for signal
RF button:
You can reach the RF button with a pointed object through the corresponding opening. This
is required to couple a new / different wireless remote control with the product. For more on
this, see the corresponding chapter.
Reset button:
The device can be reset to factory settings with a pointed object. For more on this, see the
corresponding chapter.
Feedthrough GPS receiver:
The GPS receiver is delivered pre-assembled. The GPS receiver must be placed so that a sight
connection to the sky is present with as few obstacles as possible. Particularly observe panes
that are applied with film or vaporised because they interfere with or even block the GPS signal.
The same applies for front or rear window heatings.
External power supply:
Use pins 15 and 16 to supply the device with the vehicle's battery voltage (permanent plus).
The voltage range is between 6 and 32 V/DC and thus matches nearly any important vehicle
voltage.
The current load may be up to 700 mA (peak) at bad GSM reception, active switching relays
and active GPS.
75