Commissioning - First Steps; Operating Voltage; Changing The Pin Code To „1513 - Conrad GKA100 Bedienungsanleitung

9. Commissioning - First Steps

Prior to commissioning the product, check whether it is suited for the intended application!
In case of doubt, always contact a specialist, expert or the manufacturer of the products used!
The following is needed for operation and configuration of the device:
• A common mobile phone with SIM card for configuration of the device.
• An additional SIM card (prepaid or contract) for the device.
• A voltage source (USB port or direct voltage source)

9.1 Operating Voltage

The product may be supplied with power via USB as well for testing. The battery LED shows
whether the operating voltage was connected correctly, no matter the device status:
• LED off = no external voltage supply
• LED green/red = external voltage supply present
9.2 Changing the PIN Code to „1513"
Every SIM card has a PIN code. Because the car alarm system uses its own PIN processing,
the SIM card PIN code must be changed to that of the product.
The following steps are required for this:
1. The SIM card intended for the car alarm system must be inserted in a mobile phone.
2. According to the operating instructions of the mobile phone, the PIN code must be
changed to 1513.
3. The SIM card with the changed PIN code must be removed from the mobile phone.
4. The SIM card with the changed PIN code can now be inserted in the intended device slot.
The SIM card slot for this is on the short device side.
81