Intended Use; Scope Of Delivery - Conrad GKA100 Bedienungsanleitung

2. Intended Use

The product serves to monitor an object. For this, sensors like vibration, switching inputs (up
to 32 V/DC) and the GPS signal are available. The product must only be installed in the driver
space, splash-water protection is required.
Two switching relays for 30 V/DC, 2 A can be switched remote-controlledly by consumers or
automatically. Switching the consumer must not influence the safety and operational readiness
of the vehicle.
An external microphone and a speaker permit phone calls. Interior monitoring must be
according to the statutory provisions.
Any other use than described before is not intended and may cause loss of warranty/
guarantee.
The customer is responsible for application of the product in accordance with the law. Conrad
Electronic does not assume any responsibility/liability exceeding application of the product as
described here.
No part of this product must be modified or converted.
Read these operating instructions thoroughly and carefully, they contain a lot of important
information for assembly, commissioning and operation. Observe all safety information in
these operating instructions!

3. Scope of Delivery

• Car alarm system
• Remote Control
• Microphone
• Speakers
• Light diode
• Mains cable
• Various connection wires
• Operating instructions
66