Conrad GKA100 Bedienungsanleitung Seite 84

„ALARM DISABLE" (alarm deactivated)
In this mode, GSM costs may only arise when customer interaction triggers it. The product only
sends text messages if a text message with the correct PIN or a call from a phone number in
the phone book has been received, depending on configuration.
The device will only call on direct command anymore (text message, button, call, etc.) from the
customer. The product then also cannot trigger an alarm.
Transfer to this mode is signalled with the following sound signal using the external speaker:
1/4 s sound high —> 1/4 s sound low
Switching plus (P+)
If the switching plus should be activated (12 V) while the alarm is active, this is recognised as
an alarm situation and an alarm is triggered. Deactivation of the switching plus in case of alarm
has no effect.
When the switching plus is active, no alarm sound can be output via the speaker. This has been
chosen for safety reasons to prevent the driver from being annoyed or surprised by the sudden
alarm, which may cause an accident.
Call (incoming)
A call from an unknown phone number will be rejected at once when the alarm is active
(„ALARM ENABLE"). For known phone numbers, the campaign depends on the settings for the
„INCALL" command.
84