Declaration Of Conformity (Doc); Fuse Replacement - Conrad GKA100 Bedienungsanleitung

Contaminated sensors or exhaust residue may impair system function.
It is recommended to clean the sensors with a dry and clean cloth. In case of stronger
contamination, use a cloth moistened with lukewarm water.

16. Declaration of Conformity (DOC)

We, Conrad Electronic, Klaus-Conrad-Straße 1, D-92240 Hirschau, hereby declare that this
product complies with the fundamental requirements and the other relevant regulations of the
directive 1999/5/EC.

The declaration of conformity for this product is available at www.conrad.com.

17. Fuse Replacement

The power cable for socket 15/16 is protected against overload with a separate miniature fuse.
A fuse replacement is required if the battery LED is off (no external voltage).
Proceed as follows for fuse replacement:
• Open the fuse holder, twist it out carefully.
• Replace the defective miniature fuse with a new one of the same type and the same rated
current (miniature fuse 5 x 20 mm, 0.63 A, 250 V, slow-acting trigger).
A defective fuse must never be bridged. Also never use a fuse with a higher rated
current!
• Screw on the fuse holder after inserting the new fuse.
122