Conrad GKA100 Bedienungsanleitung Seite 89

Note on the RESET command:
If a function is to be switched off or reset due to an error, the corresponding „RESET" action
must be used with the corresponding function word! This action is universally applicable for
all functions/text message commands and resets the corresponding function to the default
settings.
Example:
RESET OUT1 #1513 Switch off output 1
General Notes:
• Capitalisation is not relevant; you may use capital and small letters as you wish.
• Every new command of the same function (2nd word) will overwrite the previous settings.
• After every text message command, the device will return a test message answer to confirm
the programming (if the PIN in the text message command was correct and the phone
number is conveyed).
89