Conrad GKA100 Bedienungsanleitung Seite 108

Call activation:
In the default setting, any call is rejected so that the driver is not distracted when driving and
that the vehicle does not draw notice when parking.
For the GSM unit to be useable as a regular phone for calls, use the following command:
SET INCALL <CALL/CALLSILENT> [ALL] #1513
After activating this function, any call will be forwarded to the speakers if its phone number
matches the phone book.
After the ringtone sounds via the speaker, the right button can be used to reject the talk or the
left one to accept it.
Use the optional parameter „ALL" to forward any call to the speakers.
Use the alternative parameter „CALLSILENT" to make changes:
• Any permitted call is accepted at once without notification.
• The external speaker is deactivated during the call.
This permits listening to what happens inside.
Listening to and eavesdropping on persons is forbidden. This function must only be
used with the consent of the driver or in case of theft.
Change alarm mode:
Use this INCALL function to change the current condition of the car alarm system (functions
„ALARM ENABLE/DISABLE").
SET INCALL ALERT #1513
Now any authorised phone number from the phone book will cause the alarm system condition
to change (ENABLE/DISABLE).
The current status is indicated by the sound signal and the external LEDs after the change.

Attention!
Use of phone number ranges may permit people with similar phone numbers to
switch off the product. Using the „INCALL ALERT" function with stored phone
numbers that include placeholders (asterisks) therefore must be done with the
corresponding care!
108