Programming The „Gpszone - Conrad GKA100 Bedienungsanleitung

12.4.6 Programming the „GPSZONE"
The product may be used for zone monitoring. After programming of the permitted zone(s)
(max. 10) and after activation of the alarm mode („ENABLE"), every time the permitted zone(s)
are exceeded will cause an alarm message with the current GPS coordinate to be sent to all
phone numbers stored.
Use the following command to programme the zones:
SET GPSZONE <Latitude 1> <Longitude 1>
<Latitude 2> <Longitude 2> #1513
Latitude 1 = upper threshold (towards North)
Latitude 2 = upper threshold (towards South)
Longitude 1 = left threshold (towards West)
Longitude 2 = right threshold (towards East)
The following example shows the data input format:
Latitude – gg.gggggg N (degrees)
e.g.: 49° 59,5058' N = 49.991763 N
Longitude – ggg.gggggg E (degrees)
e.g.: 11° 57.0399' E = 011.950665 E
114