Wireless Remote Control And Its Function (Rfbutton) - Conrad GKA100 Bedienungsanleitung

12.3.2 Wireless Remote Control and its Function (RFBUTTON)

The left button of the remote control can be programmed for various functions as described
below:
Switch relay:
When the left remote control button is to switch a specified relay for a specified time, use the
following command:
SET RFBUTTON <out1/out2> <time> [SILENT] #1513
The parameter „time" represents the function or activation duration:
Value 0:
Value 1.....253:
Value 254:
Value 255:
After pushing a button, the selected relay is activated for the set (parameter „time") and
signalled with a short sound signal on the speakers.
If no sound signal is desired, this may be deactivated with the optional parameter „SILENT".
Call phone number:
You need the following special function when a specific phone number is to be called:
SET RFBUTTON CALL +49123456789 #1513
Trigger alarm (panic alarm):
The 2nd button on the remote control may be used to trigger alarm manually:
SET RFBUTTON ALERT [NOISE] [CALL] #1513
After configuration, the left button may be used to trigger alarm. In this case, all phone numbers
in the phone book will receive the corresponding alarm message.
The optional parameter „NOISE" will also output an alarm sound via the speaker to be noticed.
The optional parameter „CALL" instructs the product to call the 1st number in the phone book
(TEL1) after sending all text messages.

This is the only way to trigger alarm even in „ALARM DISABLE" mode.
This is also the only way to trigger a sound signal while the alarm sound is blocked
due to P+ = HIGH level (switching plus is active).
switch 1x
Time in seconds (1.....253 seconds)
1/4 second
1/2 second
105