Introduction; Product Description (Fig. 1 - 18); Scope Of Delivery (Fig. 1); Proper Use - Scheppach Pts400 Originalbetriebsanleitung

1. Introduction

Manufacturer:
Scheppach GmbH
Günzburger Straße 69
D-89335 Ichenhausen
Dear Customer,
We hope your new product brings you much enjoy-
ment and success.
Note:
In accordance with the applicable product liability
laws, the manufacturer of this product assumes no
liability for damage to the product or caused by the
product arising from:
• Improper handling
• Non-compliance with the operating manual
• Repairs carried out by third parties, unauthorised
specialists
• Installing and replacing non-original spare parts
• Improper use
Note:
The operating manual is part of this product. It in-
cludes important instructions for the safe, proper
and economic operation of the product, for avoiding
danger, for minimising repair costs and downtimes
and for increasing the reliability and extending the
service life of the product. In addition to the safety
instructions in this operating manual, you must also
observe the regulations applicable to the operation of
the product in your country.
Familiarise yourself with all operating and safety in-
structions before using the product. Only operate the
product as described and for the specified areas of
application. Keep the operating manual in a good
place and hand over all documents when passing the
product on to third parties.

2. Product description (Fig. 1 - 18)

1. Front handle
2. Front air filter cover
3. Lock for the air filter cover
4. Rear air filter cover
5. Throttle
6. Throttle interlock
7. Rear handle
8. Cold start lever (choke)
9. On/off switch
10. Fuel tank cap
11. Start pull cord
12. Wheels
13. Cutting wheel guard
14. Clamping screw
15. External clamping flange
16. Diamond cutting wheel
17. Washer for clamping flange
18. Inner flange
19. Water regulation screw
20. Water hose
21. Quick coupling
22. Front belt cover
22a. Allen screw
23. Fastening nuts for rear belt cover
24. Rear belt cover
24a. Retaining plate
24b. Allen screw
25. Silencer
26. V-belt
27. Front pulley
27a. Allen screw
28. Belt tensioner
29. Hexagonal bolt
30. Spark plug connector
31. Spark plug cover
32. Spark plug wrench
33. 16/18 mm open-ended spanner
34. 10/12 mm open-ended spanner
35. Phillips screwdriver
36. 5 mm Allen key
37. 4 mm Allen key
38. Mixing container
39. Fuel filter
40. Air filter
40a. Foam filter

3. Scope of delivery (Fig. 1)

Item Quantity
16 1x
20 1x
21 1x
26 1x
32 1x
33 1x
34 1x
35 1x
36 1x
37 1x
38 1x
39 1x
40 1x
41 1x
1x

4. Proper use

The petrol cutter is used for asphalt and concrete cut-
ting, in accordance with the machine size and in com-
pliance with all technical limits and safety regulations.
www.scheppach.com
Designation
Diamond cutting wheel
Water hose
Water connection quick coupling
V-belt
Spark plug wrench
16/18 mm open-ended spanner
10/12 mm open-ended spanner
Phillips screwdriver
Allen key, 5 mm
Allen key, 4 mm
Fuel mixing container
Fuel filter
Air filter
Original Operating Manual
Cutter
GB | 31