Guidance And Manufacturer's Declaration - Electromagnetic Immunity - Stryker Power-Pro Xt Bedienungs- Und Wartungshandbuch

POWER-PRO XT (CONTINUED)

Guidance and manufacturer's declaration - electromagnetic immunity

The Model 6506 Power-PRO XT cot is intended for use in the electromagnetic environment specified below . The
customer or user of the Model 6506 Power-PRO XT cot should assure that it is used in such an environment .
IMMUNITY test
Electrostatic +6 kV contact
discharge (ESD) +8 kV air
EN/IEC 61000-4-2
Electrostatic fast
transient/burst
IEC 61000-4-4
Surge
IEC 61000-4-5
+2 kV common mode
Voltage dips, short
interruptions, and
voltage variations
on power supply
input lines
IEC 61000-4-11
Power frequency 3A/m
(50/60Hz)
magnetic field
EN/IEC 61000-4-8
Note: U
is the alternating current mains voltage prior to application of the test level .
T
www.stryker.com
EMC Information
EN/IEC 60601
Compliance level
test level
+6 kV contact
+8 kV air
+2 kV for power +2 kV for power
supply lines supply lines
+1 kV for input/ +1 kV for input/
output lines output lines
+8 kV differential +8 kV differential
mode mode
+2 kV common
mode
<5% U <5% U
T
(>95% dip in U (>95% dip in U
)
T
for 0,5 cycle for 0,5 cycle
40% U 40% U
T
(60% dip in U (60% dip in U
)
T
for 5 cycles for 5 cycles
70% U 70% U
T
(30% dip in U (30% dip in U
)
T
for 25 cycles for 25 cycles
<5% U <5% U
T
(>95% dip in U ) (>95% dip in U
T
for 5 seconds for 5 seconds
3A/m
6506-009-005 REV B
Electromagnetic environment - guidance
Floors should be wood, concrete or ceramic
tile . If floors are covered with synthetic
material, the relative humidity should be at
least 30% .
Applies to:
• Cot
• SMRT Charger (6500-201-010)
Mains power quality should be that of a typical
commercial or hospital environment .
Applies to:
• SMRT Charger (6500-201-010)
Mains power quality should be that of a typical
commercial or hospital environment .
Applies to:
• SMRT Charger (6500-201-010)
Mains power quality should be that of a
T
) typical commercial or hospital environment .
T
If the user of the charger requires continued
operation during power main interruptions, it
T
) is recommended that the device be powered
T
from an uninterrupted power supply or a
battery .
T
)
T
T
)
T
Power frequency magnetic fields should be
at levels characteristic of a typical location in
a typical commercial or hospital environment .
Applies to:
• Cot
• SMRT Charger (6500-201-010)
Return To Table of Contents
1-109
English