Tools Required - Stryker Power-Pro Xt Bedienungs- Und Wartungshandbuch

STEER-LOCK MECHANISM ADJUSTMENT

Tools Required:

• 9/16" Combination Wrench
Procedure:
If your steer-lock mechanism will not engage:
• Using a 9/16" combination wrench, adjust the barrel nuts
toward the foot end of the cot (Figure 90) .
Note: After adjustment, make sure that a minimum
of one full thread is exposed on each side of the
barrel nut.
If your steer-lock mechanism will not disengage:
• Using a 9/16" combination wrench, adjust the barrel nuts
toward the head end of the cot (Figure 91) .
Note: After adjustment, make sure that a minimum
of one full thread is exposed on each side of the
barrel nut.
www.stryker.com
Service Information
6506-009-005 REV B
Figure 90
Figure 91
Return To Table of Contents
1-97
English