Starting The Machine; Stopping The Machine; Emergency Stop; Normal Switch-Off - Zipper Zi-Rpe60C Betriebsanleitung


If the machine is working in an environment e.g. on soft or uneven ground, make sure to
reduce the horsepower to the lowest level to prevent the machine from sinking. On slopes
(max. 20° allowed!!!), make sure that the machine does not tilt.
 Pay particular attention to the following particularly dangerous areas:
During tunnel work, good ventilation must be provided to prevent accidents. In addi-
o
tion, the ventilation must be monitored.
16.3

Starting the Machine

16.4 Stopping the Machine

16.4.1 Emergency Stop

In case of danger and/or in an emergency situation, you can quickly switch off the machine with the
speed governor by pushing it completely into the STOP position.

16.4.2 Normal switch-off

1. Set the upper throttle lever to "minimum" and let the engine run idle for approx. 3 minutes
at low engine speed.
2. Then set the engine ON/OFF switch (ignition switch) to the OFF position.
3. Close the fuel switch.
4. Wait until the engine has cooled down before storing the machine.
17

MAINTENANCE

Hot surfaces and rotating machine parts while the engine is running can cause serious
injury or even death. Always stop the machine before carrying out any conversion, ad-
justment, cleaning or maintenance work and secure it against unintentional restarting.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
1. Fold up the handle and clamp the transport wheel in
the rubber holder.
2. Turn the fuel valve to the "O
3. Set the engine
ON
the "On" position.
Note: The closed position of the choke lever enriches the
fuel mixture for starting a cold engine. The open position
provides the correct fuel mixture for normal operation af-
ter starting and for restarting a warm engine.
4. Turn the choke lever to the "Closed" position, only for
cold engine.
5. Set the throttle lever to "half throttle" (= middle posi-
tion between "fast" and "slow").
Note: Do not pull the starter rope through to the end and
do not let it rewind after pulling, but only rewind it quickly.
6. Grab the starter handle and pull it out slowly. The re-
sistance becomes strongest at a certain point. This
point corresponds to the compression point. Let the
rope roll back a little from this point and then pull it
out powerfully.
7. Turn the choke lever to "Open when the engine is run-
ning.
8. Open throttle further Machine starts compacting.
W A R N I N G
MAINTENANCE
" position.
N
/ switch (ignition switch) also to
OFF
ZI-RPE60C | ZI-RPE90C
36