Auerswald COMfortel 3500 Inbetriebnahmeanleitung Seite 52

Preparation
Requirements
– One or two power supply plug(s) with type no. S110001/EU/ZIS616V
(COMfortel 3200) resp. FW7577/EU/40 (COMfortel 3500) (only one power
plug is contained in the scope of delivery)
Steps to Take
1.
Only for the operation without Power over Ethernet: Remove the bridge
plug from the corresponding jack marked with
telephone.
2.
Only for the operation without Power over Ethernet: Insert the RJ-45 con-
nector of the power supply into the jack labelled with
of the telephone.
Do not set up the connection to the 230 V mains supply before the tele-
phone is actually commissioned.
3.
If operated with two or three key extension modules: Insert the RJ-45 con-
nector of the power supply into the jack labelled with
of the key extension module.
Do not set up the connection to the 230 V mains supply before the tele-
phone is actually commissioned.
Fig. 8: Connecting the power supply plugs
52
COMfortel 3200/3500 - Firmware Version 1.8B - Setup Guide 04 02/14
on the lower side of the
on the lower side
on the lower side