Accident Prevention Check; Operation Of Industrial Trucks In The Plant Area; Running-In Instructions; Checks Before Initial Operation - Linde T 20 R 01 Bedienungsanleitung

SAFETY RULES
Accident prevention check
The accident prevention rules require that an industrial
truck must be checked at least once a year for proper
working condition by trained personnel. The inspection
results must be recorded in a written report. Please
contact your authorised distributor for this inspection.
Operation of industrial trucks in the plant
area
ATTENTION
Many plant areas are so-ca lied public traffic
areas.
We advise you to check if your company
liability insurance covers any damages oc-
curring with your fork truck against third
parties in public traffic areas.
Running-in instructions
Your truck can be operated directly, however, avoid
sustained high loads in the first 50 hours of operation.
During initial operation and after each wheel change,
tighten the wheel nuts daily prior to starting operation
until they are firmly seated, i.e. until no further tightening
is possible.
NOTE
Tighten opposite wheel nuts to a torque as specified in
these operating instructions.
28
Checks before initial operation*
- Battery condition, electrolyte level and specific gravity
- Condition and tightness of cables, connectors and
connections
- Hydraulic oil level
- Oil level in gearbox
- Check for leaks
- Tightness of wheel nuts, tighten if necessary
- Operation of horn
- Operation of emergency stop button
- Operation of lifting device
- Operation of steering system
- Operation of braking system
Torque to 100 Nm
ATTENTION!
after 8 hours
BEGINNING OPERATION
Daily checks*
- Battery state of charge
- Battery condition, electrolyte level and specific gravity
- Hydraulic oil level
- Check for leaks
- Operation of emergency stop button
Operation of horn
- Operation of braking system
*
A description of the service can also be located in the
alphabetical index.