Alpinestars SUPERTECH R10 Bedienungsanleitung Seite 19

IMPORTANT USER INFORMATION
11. REPLACEMENT PARTS
The following replacement and parts are available from your Alpinestars' authorized Dealer:
a) Clear Shield, anti-scratch and anti-fog, homologated
b) Medium smoke Shield, anti-scratch and anti-fog, not homologated
c) Dark smoke Shield, anti-scratch and anti-fog, not homologated
d) Silver mirror shield, anti-scratch and anti-fog, not homologated
e) Photocromic shield, anti-scratch and anti-fog, homologated
f) Top Vent
g) Rubber Tap for central Chin Vent
h) Standard Spoiler
i) Race Spoiler
j) Shield Mechanism
k) Crown Pad
l) Cheek Pads
m) Cheek Pads "+5 mm"
n) Chin Strap Covers
o) Chin Curtain
p) Wind Deflector
q) Breath Deflector
r) Bag
s) Pinlock lens
®
t) Pinlock and tear offs
®
u) Tear off pack
Always use genuine Alpinestars' Replacement Partswhen replacing any parts
of the helmet.
SAFETY ADVICES
1. Helmet Care
Be aware that your helmet is an important piece of safety equipment and when handling your helmet take note of the
following points:
a. When dirty, clean the shell of the helmet using only a clean damp cloth and mild soap and water. Dry immediately
afterwards.
b. To remove flies from the Shield, place a clean wet cloth on top of the Shield and leave it on the Shield for a few
minutes to soak, then wash the Shield surface with neutral soap and water, and dry it using a soft cloth.
c. To keep the inside of the helmet's interior clean and fresh, apply a water-based upholstery cleaner to the cheek pads
and comfort padding. Wipe away the dirt and allow it to dry completely.
d. Avoid dropping your helmet or impacting it on objects, as it will weaken or damage the shell and/or the impact
absorbing liner. Always place your helmet on a flat stable surface, do not balance it on the top of the bike or on the
end of the mirror stalks.
e. Periodically inspect the helmet for damage and to ensure that the Shield, ventilation system. and chin strap function
properly.
WARNING
19