HT Instruments T2000 Bedienungsanleitung Seite 47

5.5. MANAGING THE MEMORY
5.5.1. Storage of data in the memory
With the result of a resistance measurement shown on the display, by shortly pressing the
the instrument automatically saves the result in the instrument's memory, starting
MEM key,
from location "01" up to the location "99" (see Fig.
Fig. 27: Saving the result of a resistance measurement in the memory
If the internal memory of the clamp is full,
by shortly pressing the MEM
instrument shows the screen in Fig. 28 for 2
seconds, then goes back to the previously
set real-time measuring
5.5.2. Recalling the results on the display
1. Press the ON/OFF key to switch on the
2. Press and hold the MEM key (>2s) to enter the memory recall mode. The "MR" symbol is
shown (see Fig. 29).
In case there are no data saved in the
internal memory, the instrument shows the
screen in Fig. 30.
3. Shortly press the A key (T2000), RS232 key (T2100) or  key to respectively
increase or decrease the number of the memory location and display the saved
shortly press the MEM key to quit this mode.
4. Press and hold the MEM key (>2s) in
order to show the value of the parallel
resistance calculated basing on all the
results saved in the instrument's memory
- see 5.2.3.1 (indicated by "rP" symbol
on the display). Shortly press the
RS232 key or  key to quit this
mode and go back to the results stored.
key, the
mode.
instrument.
Fig. 29: Recalling result to the display
EN – 18
27).
Fig. 28
Fig. 30
Fig. 31
T2000-T2100
data, or