Werbung
Verfügbare Sprachen
Verfügbare Sprachen
JMA
MOVE GO
IMPORTANT
Due to the safety regulations governing air and maritime
transport, the machine battery comes separate. Follow
the steps below to connect it:
Before proceeding, make sure that the on/off
switch (17) and the master switch (20) are OFF.
1) Turn the machine onto its back. Remove the four screws
(O) to take off the protective screen.
2) Plug in the yellow connector. Then replace the protective
screen and return the machine to its natural position. Using
the power adapter supplied with the machine, charge it to
100% before using it.
Index
005
1. INTRODUCTION AND GENERAL OVERVIEW
1.1 OVERVIEW
1.2
TRANSPORT AND PACKAGING
1.3
IDENTIFICATION LABEL
006 — 007
2.
SAFETY MEASURES
2.1
REGULATIONS
2.2
SAFETY DEVICES
2.3
RESIDUAL RISKS
008
3
INSTALLATION AND PREPARATION OF THE MACHINE 08
3.1
ENVIRONMENTAL CONDITIONS IN THE WORKSHOP
3.2
CHARACTERISTICS OF THE LOCATION FOR INSTALLATION 08
3.3
PREPARATION OF THE MACHINE
009 — 011
4.
CHARACTERISTICS OF THE MACHINE
4.1
ACCESSORIES
4.2
WIRING DIAGRAM
4.3
TECHNICAL DATA
4.4
MAIN PARTS OF THE MACHINE
4.5
COMPONENTS AND FUNCTIONAL PARTS
012 — 014
5
OPERATION AND FUNCTIONS
05
05
5.1
CUTTING PROCESS
05
5.2
KEY CUTTING
05
015 — 018
6.
MAINTENANCE
06
6.1
CLAMP REPLACEMENT
06
6.2
CLAMP ADJUSTMENT
06
6.3
TIGHTENING AND REPLACING THE BELT
07
6.4
MOTOR REPLACEMENT
6.5
REPLACING THE LEDS
6.6
REPLACING THE BATTERY
6.7
REPLACING THE ELECTRONIC CARD
08
6.8
REPLACING THE JACK CONNECTOR
6.9
REPLACING THE MASTER SWITCH
08
019
09
7.
WASTE DISPOSAL
09
7.1
SWARF
09
7.2
PACKAGING
09
7.3
MACHINE
09
110 — 116
10
8.
FIGURES
O
20
O
O
O
12
12
13
15
15
15
16
16
16
17
17
17
17
19
19
19
19
110
Werbung
