MACHINE CHARACTERISTICS
NOTE: When the battery charge level falls very low, the
cutter will suddenly stop rotating. This does not mean that
the machine is faulty but rather that the battery needs to be
recharged.
TEST
TEST
To recharge the battery, just connect the power adapter
supplied with the machine to a 220-110 V power supply and
the jack connector (19) located on the rear of the machine.
Make sure that the yellow connector on the battery
is connected. Otherwise, the battery will not charge.
To prolong the life of the battery, it is recommen-
ded not to use the machine during charging.
Always use original power adapters and cables.
25%
25%
50%
50%
75%
75%
100%
100%
11
11 11 11
EN