Werbung
Verfügbare Sprachen
Verfügbare Sprachen
JMA
MOVE GO
KEY CUTTING MACHINE
1) Turn the machine onto its back.
2) Remove the protective panel from the bottom of the ma-
chine. Loosen the four securing screws to do so.
3) Disconnect the yellow power connector from the battery.
4) Return the machine to its natural position.
5) Remove the handle (19) by releasing the two screws (T8)
on the right-hand side and the two screws on the left-hand
side.
6) Release the four screws (T2) securing the protective shield
on the motor (B) and remove it.
7) Disconnect the cable connector from the master switch.
8) Using a spanner, release the nut (T14) securing the master
switch to the machine.
9) Remove the master switch (20) and the protective screen
(21).
10) Install the new master switch following the same steps
but in reverse order.
Werbung
