3M PELTOR WS LiteCom Pro III Headset Bedienungsanleitung Seite 284

Q) TECHNICAL DATA
POWER
WS LiteCom Pro III are powered by a rechargeable Li-ion battery pack:
TM
3.7 V, 1350 mAh (ACK082
3.7 V, 1800 mAh (ACK081)
OPERATING TIME
Intrinsic safe models Expected operating time,
in power save mode, (according to standardized
measurement) in room temperature with ACK082
Non Intrinsic safe models Expected operating
time, in power save mode, (according to
standardized measurement) in room temperature
with ACK081
RADIO
Frequency range
Operation mode
Antenna
Channels
Channel raster
Channel spacing
Modulation
Receiver sensitivity
Output power
EXTERNAL INTERFACE PORT
3M PELTOR Type J111-A
TM TM
Connector for external equipment:
3M PELTOR Type J111-A
TM TM
SAR Value/ Valeur DAS: 0.04 W/kg.
High power: ~12h
Medium power: ~13h
Low power: ~14h
High power: ~16h
Medium power: ~17h
Low power: ~18h
403 - 470 MHz
Half-duplex
¼ wave, integrated whip antenna
Fixed to the headset
Omni directional
Gain: 2 dBi
70 programmable channels
3.125 kHz, 6.25 kHz, 12.5 kHz, 25 kHz
12.5 kHz and 25 kHz
Analog: Max narrow 2.5 kHz (FM), Max wide 5 kHz (FM)
Digital: 4-level FSK, 2.5 kHz max deviation
Typical -120 dBm
High power: 200 mW e.r.p
Medium power: 20 mW e.r.p
Low power: 10 mW e.r.p
4-pole connector for external equipment
Pin 1 EXTERNAL PTT
Activated when shorted to Pin 2 (ground)
Pin 2 GROUND
Pin 3 INPUT
The input signal is mixed with the WS™ LiteCom Pro III Headset audio
output level (speaker output).
Pin 4 BOOM MICROPHONE OUTPUT
Applied signal at the boom microphone input comes out on pin 4
2.25 mV Microphone input = 10 mV output.
Bluetooth: 4.06 dBm
Bluetooth Low Energy: -3.19 dBm