SICK LFP inox Betriebsanleitung Seite 83

LFP Inox
Parameter
QAFAIL
SimCur
SimVol
DspVal
Filter
SimLev
RstFac
8014485/YE12/2014-08-20 © SICK AG • Level sensors • Germany • Subject to change without notice
6 Menu overview
Description
Output behavior according to NE43 in the event of a fault (function only available
if it was selected under QATYP of the current output)
3.5 mA = Analog current output is set to 3.5 mA in the event of a fault
●
21.5 mA = Analog current output is set to 21.5 mA in the event of a fault
●
2)
See chapter „5.3 Testing the configuration"
See chapter „5.3 Testing the configuration"
2)
Display settings
Distan = The display shows the distance in mm in relation to the end of the
●
probe.
QaPerc = The display shows the filling level as a % in relation to the QA analog
●
output with the respective thresholds QAHIGH and QALOW.
QaBarG = The display shows a bar chart in relation to the QA analog output
●
with the respective thresholds QAHIGH and QALOW.
QaSign = The display shows the current QA output value in mA or V.
●
QxSign = The display shows the output states.
●
See chapter „5.2 Filtering the measured values"
See chapter „5.3 Testing the configuration"
Resetting of the set parameters back to the factory settings
EN
Operating instructions
83