Factory Settings - Sick Lfp Inox Betriebsanleitung

LFP Inox

9.9 Factory settings

Parameter Factory setting
SP1 80% of the probe length measured from the end of the probe
RP1 5 mm below SP1
OU1 Q1_Hno
For 5-pin versions: 20% of the probe length measured from the end of the probe
SP2
For 8-pin versions: 60% of the probe length measured from the end of the probe
RP2 5 mm below SP2
OU2 Q2_Hno
TYP2 Q2_PNP
QAHigh 50 mm below start of probe
QALOW 10 mm above end of probe
QAPOL QA_Nrm
QATYP Auto
QAFAIL 3.5 mA
SimCur SimOff
SimVol SimOff
DspVal Distan
Filter Off
SimLev SimOff
TrsHld 100
MaxCol Depending on measuring mode : HiSped = AnySped, HiAcc = 10 cm/s
MeasMd Depending on probe length: < 2005 mm = HiSped, > 2005 mm = HiAcc
CalRng 6005mm
FomSta inactive
Limit 90
Offset 0 mm
Unit mm
Lock inactive
8014485/YE12/2014-08-20 © SICK AG • Level sensors • Germany • Subject to change without notice
9 Technical data
EN
Operating instructions
103