Normally Open With Error Signal; Normally Closed With Error Signal - Sick Lfp Inox Betriebsanleitung

LFP Inox

3.5 Normally open with error signal

Application
If there is an error message at the LFP, this can be transferred using a switching contact.
Configuration
Configure the Qx switching output as normally open
■
Set parameter to Qx_Eno in the QxMENU-OUx menu
○
Select electrical property (NPN/PNP/DRV (Push-Pull))
■
Select parameters in the QxMENU-TYPx menu
○
The following information applies:
○
Qx-PNP = Switching output in PNP circuit
▫
Qx-NPN = Switching output in NPN circuit
▫
Qx-Drv = Switching output in Push-Pull function
▫

3.6 Normally closed with error signal

Application
If there is an error message at the LFP, this can be transferred using a switching contact.
Configuration
Configure the Qx switching output as normally closed
■
Set parameter to Qx_Enc in the QxMENU-OUx menu
○
Select electrical property (NPN/PNP/DRV (Push-Pull))
■
Select parameters in the QxMENU-TYPx menu
○
The following information applies:
○
Qx-PNP = Switching output in PNP circuit
▫
Qx-NPN = Switching output in NPN circuit
▫
Qx-Drv = Switching output in Push-Pull function
▫
8014485/YE12/2014-08-20 © SICK AG • Level sensors • Germany • Subject to change without notice
3 Configuring the switching outputs
EN
Operating instructions
73