Hitachi RPK-0.6FSNH3M Installations- Und Betriebshandbuch Seite 22

Troubleshooting
13.1 CONTACT DISTRIBUTOR
If the trouble still remains even after checking previous items or
other troubles not mentioned in the previous occurs, stop using
the product and contact your distributor or contractor.
The protection devices (fuse, breaker, ELB, etc) are frequently activated
or the main power source switch does not work.
Water leakage from indoor unit.
PC-ARF
The RUN indicator (red) is flashing.
The indoor unit number, the alarm code, the unit model code and the
connected number of indoor units are displayed on LCD.
In case that the plural indoor units are connected to one remote control
switch, the above abnormality informations for each indoor unit are
displayed one by one
Check the details on LCD and contact your distributor.
01-02
22
Alarm Code:
MODEL : b .02
SEL. OP MODE
PC-LH3B
For the wireless remote control switch, the alarm codes are indicated by
the flashing times of indicator on indoor unit.
Inform the following items to a distributor.
1 Unit model
2 Content of trouble
3 Alarm code No. on LCD or detail of flashing indicator.
16
Trouble
Indoor unit number
ALM RST
ADDR
ENT.
OK
PMML0292A rev.2 - 09/2015 - P5416572
C A U T I O N
If abnormality (burnt odor, etc.) occurs, stop the operation and
turn OFF the main power source immediately. If not, it may cause
breakage of the product, an electric shock or a fire. Contact your
distributor or contractor.
Action before contact
Turn OFF the power source.
Stop the operation.
Refer the alarm code table.
Contact your distributor and inform the indication detail on the remote
control switch.