Inhaltsverzeichnis
Werbung
Routing the Cable Assembly
The cable is wrapped in packing material and attached to the equipment frame
for shipment. Proper cable routing is shown in the following figure.
Figure 10: Correct cable routing on movement frame
Seated Dip Assembly Guide: Routing the Cable Assembly
If necessary, use the following procedure to restore the cable to its original
route.
To route the cable on the movement frame:
1. Using a Phillips screwdriver, remove the screws holding the plastic covers
on the pulleys.
Figure 11: Pulley cover screw location
2. Using a ³ ₈-inch hex bit and a ³ ₄-inch socket wrench, remove the pulley,
bolt, locknut and two washers.
Figure 12: Pulley removal
8
Werbung
Kapitel
Inhaltsverzeichnis
