Precor Discovery Series Selectorized Line Benutzerhandbuch Seite 56

To attach the equipment to the weight tower:
1. Locate the point where the base support attaches to the weight tower.
Using a ⁷ ₃₂-inch hex bit and a ⁹ ₁₆-inch socket, remove the two bolts, four
washers, and two nuts installed there and set them aside.
2. Locate the point where the cross support attaches to the weight tower.
Using a ⁵ ₁₆-inch hex bit and a 1-inch socket, remove the four bolts and two
domed washers.
3. Attach the base support to the weight tower using the fasteners removed
previously. Partially tighten the fasteners.
Figure 7: Base support attachment to weight tower
Seated Dip Assembly Guide: Assembling the Equipment
4. Attach the cross support to the weight tower using the fasteners removed
previously. Partially tighten the fasteners.
Note: Be sure to orient the dome washers as shown in the following figure.
Figure 8: Cross support attachment to weight tower
6