Routing The Cable Assembly - Precor Rear Delt / Pec Fly Benutzerhandbuch

Routing the Cable Assembly

The cable is wrapped in packing material and attached to the equipment frame
for shipment. Proper cable routing is shown in the following figure.
Figure 5: Full cable route
Rear Delt/Pec Fly Assembly Guide: Routing the Cable Assembly
If necessary, use the following procedure to restore the cable to its original
route. Begin routing the cable on the equipment frame before you route it on
the weight stack.
To route the cable on the movement frame:
1. Route the pulleys around the cams and over the top pulley.
Figure 6: Cable connection on cam
2. Remove the pulley covers using a #2 Phillips head screw driver.
Figure 7: Cable route on cams
6