WIKA TLS-S Betriebsanleitung Seite 28

6. Faults
6. Faults
Personnel: Skilled personnel
EN
Faults
The power supply is
connected, but the tuning
fork is not vibrating. The
status LED is off.
The power supply is
connected and the tuning
fork is vibrating. The status
LED is off.
The power supply is
connected and the status
LED is blinking.
The power supply is
connected and the tuning
fork is vibrating. The LEDs
light up in reverse order.
28
If faults cannot be eliminated by means of the listed measures, the
instrument must be taken out of operation immediately.
▶
Contact the manufacturer.
▶
If a return is needed, please follow the instructions given in
chapter 8.2 "Return".
For contact details, see chapter 1 "General information" or the back page
of the operating instructions.
Causes
Error in the electrical
wiring. The power supply is
connected incorrectly.
Electronics are defective.
Status LED is defective.
Electronics are defective.
Status LED is defective.
Electronics are defective.
The mechanics of the tuning
fork are damaged.
Error in the electrical
wiring. The power supply is
connected incorrectly.
Electronics are defective.
WIKA operating instructions, models TLS-S, TLS-C, TLS-H
Measures
Check the electrical wiring
with the instrument-specific
connection diagram.
Contact the manufacturer.
Contact the manufacturer.
Contact the manufacturer.
Contact the manufacturer.
Contact the manufacturer.
Check the tuning fork for
external damage and contact
the manufacturer.
Check the electrical wiring
with the instrument-specific
connection diagram.
Contact the manufacturer.