Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6.9. Checking Continuity
Follow these steps to check a circuit's continuity.
1. Set the rotary selector to
2. Press select until Continuity symbol
2. Plug the black test lead into your meter's COM terminal
and the red test lead into your meter's V//Hz/-
terminal.
3. Remove power from the circuit.
4. Connect the test leads to the circuit.
Note:
The buzzer sounds if the measured resistance is below about
50 approximately.
Warning! Never perform a continuity measurement on a
circuit that has power connected.
57
is shown
Werbung
