Werbung
Verfügbare Sprachen
Verfügbare Sprachen
6. How to make measurements
6.1. Measuring AC/DC voltage
Understanding Phantom readings:
In some DC and AC voltage ranges, when the test leads are
not connected to any circuit, the display might show a
phantom reading. This is normal. The meter's high input
sensitivity produces a wandering effect. When you connect
the test leads to a circuit, accurate reading appears.
WARNING!
Do not try to measure a voltage greater than 1000V DC or
AC. Do not use the rotation knob to switch function with
attached voltage.
Follow these steps to measure DC/AC Voltage.
1. Set the rotary selector to the desired position. Select the
range as required for the voltage level to be measured. If
you do not know the voltage level, start with the range
switch set to the highest voltage position and reduce the
setting as needed to get a reading.
2. Plug the black test lead into the meter's COM terminal
and the red test lead into the V//Hz-terminal.
3. Connect the test leads to the DC/AC voltage source you
want to measure.
50
Werbung
