Wolkenstein IN4-DA-2FZA+W Bedienungsanleitung Seite 107

8. A red dot next to the indicator of the power level goes on
to indicate that the timer has been activated for this cooking
zone.
9. Set the desired cooking time (1 - 99 minutes) using the sliding
sensor by swiping your fingertip over the glide sensor or by
touching the glide sensor at any point,
a. If both digits of the timer indicator flash and you swipe
your fingertip over the sliding sensor, the countdown
time is increased or decreased by 10 minutes.
b. If a digit on the timer indicator flashes and you swipe your
fingertip over the sliding sensor, the countdown time is
increased or decreased by 1 minute.
10. The indicator of the timer displays the set cooking time (e.g.,
6 minutes)
11. When you have finished the setting, the countdown of the
set time starts. When the set countdown time (cooking time)
has elapsed, an acoustic signal sounds for 30 seconds and
the corresponding cooking zone is switched off
automatically.
12. Beware of the hot surfaces of the cooking zones! An « H »
indicates which cooking zones are still hot.
13. Repeat steps 5. - 9. to set the timer for another cooking zone.
If you want to change the set countdown time (cooking time) after programming,
you need to start at step 5. again.
WARNING! If the timer is set for one cooking zone only, the other
activated cooking zones remain in operation after the set time has
elapsed.
A
UTOMATIC SWITCH
 If you operate more than one cooking zone automatically, the system displays the
smallest time value. For example: if you have set cooking zone A (e.g., power
level 5) to 6 minutes and cooking zone B (e.g., power level 6) to 3 minutes, the
smallest time value
indicator indicates that this cooking zone is selected.
H
OW TO SET THE TIMER
-
OFF FUNCTION OF MORE THAN ONE COOKING ZONE
03
is displayed. The red dot beneath the power level
« »
~
107
:
~