Residual Heat Indication - Wolkenstein IN4-DA-2FZA+W Bedienungsanleitung

(
SEVERAL COOKING ZONES ARE IN OPERATION
1. Select the cooking zone you want to switch off using the
sensors for the
corresponding operating panel (e.g.,
control panel); see also fig. in chapter 3.1 I
.
INCL EXTRACTOR FAN
2. Set the power level of the relevant cooking zone to « » using
the sliding sensor.
3. After a few seconds, the relevant cooking zone is deactivated.
4. Always switch off the entire appliance using the
« O / O » -
N FF SENSORS
indicators/LEDs are switched off (except for the residual
heat indicators / s.
).
INDICATION
5. Beware of the hot surfaces of the cooking zones! An « H »
indicates which cooking zones are still hot.
6. You can use the residual heat for saving energy when starting a new cooking
procedure on a cooking zone which is still warm / hot.
H
OW TO SWITCH OFF ALL COOKING ZONES SIMULTANEOUSLY
(
SEVERAL COOKING ZONES ARE IN OPERATION
1. Touch the « O
(
BOTH SIDES OF THE HOB
zones and the respective side of the hob at the same time.
2. Beware of the hot surfaces of the cooking zones! An « H »
indicates which cooking zones are still hot.
3. You can use the residual heat for saving energy when starting a new cooking
procedure on a cooking zone which is still warm / hot.

4.5.1 Residual heat indication

 The appliance is equipped with a residual heat indicator « H ».
The glass / cooking zones may become hot if they are heated by hot cookware.

H
OW TO SWITCH OFF ONE COOKING ZONE
SELECTION OF THE COOKING ZONES
.
. The acoustic signal is activated and all
chapter
/ O » -
N FF SENSORS OF THE INDUCTION HOB
). This switches off the cooking
COOKING ZONE
NDUCTION HOB
4.5.1 R
ESIDUAL
~ ~
104
)
of the
B/left
HEAT
)