Introduction; Intended Use - Voltcraft Vc331 Bedienungsanleitung

1 Introduction

Dear customer,
Thank you for purchasing this product.
If there are any technical questions, please contact:
www.conrad.com/contact

2 Intended use

The product is a clamp meter and can be used to measure and display various
electrical parameters.
The product is in accordance with the safety requirements for Electronic Measuring
Equipment, EN 61010-1 and EN 61010-2-032.
The product conforms to CAT II 600 V and CAT III 300 V:
■
MEASUREMENT CATEGORY II is applicable to test and measuring circuits
connected directly to utilization points (socket outlets and similar points) of the
low-voltage MAINS installation.
■
MEASUREMENT CATEGORY III is applicable to test and measuring circuits
connected to the distribution part of the building's low-voltage MAINS installa-
tion.
The product is designed for private and commercial use.
In commercial institutions, the accident prevention regulations of the Employer's Li-
ability Insurance Association for Electrical Systems and Operating Materials are to
be observed.
The product can be used in schools and training centres. The use must be super-
vised by trained personnel.
The product is intended for indoor use only. Do not use it outdoors.
Contact with moisture must be avoided under all circumstances.
If you use the product for purposes other than those described, the product may be
damaged.
Improper use can result in short circuits, fires, electric shocks or other hazards.
The product complies with the statutory national and European requirements.
For safety and approval purposes, you must not rebuild and/or modify the product.
34