ACD GRUPPE MAX BE Kurzanleitung Seite 75

NOTE
Please do not exceed the maximum load, otherwise this will trip the internal fuse. For the relevant
values, please see Chapter 25 technical data.
Press the On/Off switch on the front (switch light lights up) to switch on the power (24 V DC (option) and 230
V AC). The mobile workstation is now ready to use.
Next, check the current charge state of the batteries by looking at the display of the built-in battery controller.
Figure 23: Battery controller, On/Off switch
NOTE
MAX BE Li-Ion:
Display 100 % – batteries are "full"
•
Display <= 10 % – batteries are "empty"
•
The MAX BE Li-Ion does not always need to be charged to 100 %; charging can be interrupted at
any time, interim charging is possible.
CAUTION
Please note that if the MAX BE Li-Ion drops to a residual capacity of 12 %, an acoustic signal will
sound. After that, you will have time to charge up the MAX BE Li-Ion. This signal can be cancelled
by pressing any key on the battery controller.
When the residual capacity drops to approx. 10 %, the automatic shut-down of all consumers
follows; this involves the risk of system crashes when working with unsuitable PCs (e. g. PCs
without battery back-up).
To switch off the mobile workstation and the equipment connected to it, press the On/Off switch on the front
again (switch light goes out).
MAX BE_Kurzanleitung_Brief_Overview_V1.00_de_en 75 / 100