ACD GRUPPE MAX BE Kurzanleitung Seite 54

Electrical devices may only be connected by specialist electricians or persons trained
•
in electrical engineering.
The mobile workstation MAX BE may only be operated by one instructed person.
•
Only use tested electrical devices. Only devices that are regularly tested according to
•
DIN VDE 0701-0702 "Inspection after repair, modification of electrical appliances –
Periodic inspection on electrical appliances – General requirements for electrical
safety" or the respective national provision may be used.
The total output of all devices must be harmonised with the output of the mobile
•
workstation. The maximum output may not be exceeded.
• Devices must be installed and connected properly.
Regularly check the devices and installation in terms of safety, damage and wear.
•
Only devices that have been attached to the mobile workstation MAX BE may be
•
operated.
Damaged or unsafe devices may not be used.
•
The mobile workstation must be regularly examined in accordance with DIN VDE 0701-
•
0702. The German Statutory Accident Insurance Association (DGUV) Directive 3
defines the test deadline and the test type.
The batteries must be charged at regular intervals if the mobile workstation is not used
•
for an extended period. Disconnect the battery plug if the mobile workstation is
decommissioned for periods longer than 2 months.
These instructions are summarised on a warning sign attached to the cladding interior.
Figure 3: Warning sign on the interior trim Mobile workstation
MAX BE_Kurzanleitung_Brief_Overview_V1.00_de_en 54 / 100