Initial Set-Up; Warnings; General Warnings; Moving - Acd Gruppe Max Be Kurzanleitung

If visible damage is present, safety is no longer guaranteed! In the event of damage, do not put the
mobile workstation and connected devices into operation!

16 Initial set-up

In the future, the mobile workstation will be delivered with the battery plug unplugged to prevent deep
discharge until the first set-up.
The following steps must be followed for initial set-up:
1. Remove the rear panel
2. Insert the battery plug (bright plug) into the electronics box
3. Perform a complete charging cycle

17 Warnings

17.1 General warnings

DANGER
Before you open the battery module or the electronics box, switch off the mobile workstation
using the On/Off switch, disconnect the low-power charger connection cable and unplug the
battery tray connection cable. If a DC/AC converter is installed, voltages of up to 1,000 V can occur
which can cause injury or even fatality in the event of incorrect handling or operation. This may
also cause severe material damage. Touching live parts of the cart, especially on the output side of
the DC/AC converter, can cause severe or even fatal injuries.
After automatic shutdown due to overheating or overloading, the inverter may switch on again
automatically. More information on this and possible malfunctions and their causes is available in
the chapter: Information on installation parts,
DC/AC Konverter or in the enclosed manual for the DC/AC converter.

17.2 Moving

WARNING
Danger of tipping or falling!
Observe the maximum weight load of the mobile workstation or individual shelves.
• Do not lean your body weight onto the handle.
• Never exceed the permitted total weight and load.
MAX BE_Kurzanleitung_Brief_Overview_V1.00_de_en 56 / 100