Werbung
ENGLISH
Troubleshooting
e |s the computer on?
e Has the power supply cable of computer been connected cor-
26
rectly?
e Has the label of media peeled off?
insert the supplied pin into manual eject hole to open the tray.
Tray fails to close.
|@e Has the disc been inserted correctly?
28 « 30
22
e Has the drive's SCSI ID been set correctly?
e Has the drive's terminator been set correctly?
e Are the drive and computer connected correctly?
e Has a floppy disk been left inside the computer?
Tray fails to open.
18
Computer
fails to
work,
e Is the total length of SCSI cable shorter than the length speci-
fied by the SCSI host adaptor to be used?
« Has the drive's terminator been set correctly?
e Are the drive and computer connected correctly?
e Is the device driver software installed correctly?
Drive cannot be ac-
cessed normally.
e Is the device driver installed correctly?
Cr in case drive letter of CD-ROM/DVD-ROM side is recognized
only, device driver software is not installed.
e Is the SCSI host adaptor recognized correctly?
e Did you initialize (format) the DVD-RAM disc?
e Did you access the drive letter assigned to the drive?
e Did you insert a single-sided DVD-RAM disc with the label side
facing up?
els the DVD-RAM disc dirty?
èe Has condensation formed in the drive?
(Wait an hour or so after turning on the computer for the drive to
dry and then try operating.)
Drive is not recog-
nized in Windows.
Cannot read or write
DVD-RAM disc.
e Did you access the drive letter assigned to the drive?
e Only discs supported by this drive can be used.
è Is the disc inserted correctly so that the operation lamp turns
green?
e Did you insert the discs with label facing up?
e Are you using correct software program for playing the discs?
e Is the disc dirty, scratched, cracked, warped, written on the sur-
face or is a label put on the disc?
Has condensation formed in the drive?
(Wait an hour or so after turning on the computer for the drive to
dry and then try operating.)
e Have you set the driver's region number?
Discs
cannot
be
read.
No sound from the PC
speaker {or the speak-
ers with builtin amplifier)
Operating
indicator
lamp blinks
re
e |
e Have the drive and sound board been connected correctly?
VOT8697
Werbung
