Werbung
ENGLISH
Rear panel of this DVD-RAM drive
Rückwand dieses DVD-RAM-Laufwerks
Panneau arrière du lecteur DVD-RAM
VOT8697
Jumper pin
Jumper Pin
Broche de cavalier
"OFF" HOI
came || GSE
A
Jumper pin setting
I When you insert a jumper pin, "ON" is set.
@ Factory use only (No jumper pin)
6 © O SCSI ID setting
© Factory use only (No jumper pin)
@ TERMINATOR setting
@ Factory use only (No jumper pin)
EX
Terminator setting
(Factory Default: ON)
The terminators must be set properly when SCSI
units (including the DVD-RAM drive) have been
connected to the computer.
e When the DVD-RAM drive is a terminating de-
vice (for example, illustration @, © on page
20.)
Set to ON.
e When the DVD-RAM drive is not a terminating
device (for example, illustration ® — © on page
20.)
Set to OFF.
d
SCSI ID setting (Factory Default: 4)
SCSI IDs are numbers identifying each SCSI unit.
Consequently, SCSI !Ds must be set so that no
two units duplicate each other on the SCSI bus.
Note:
Generally, the SCSI IDs are set as follows:
e Hard disk drive: 0
e CD-ROM drive: 3
e SCSI host adaptor: 7
Check the SCSI ID (refer to devices instruction
manual) for each device connected on the SCSI
bus.
Set the DVD-RAM drive's ID so as not to
duplicate any other device's ID.
Caution:
e Do not mount the jumper pins crossways
or in positions other than those specified
as this may cause malfunction.
A Not allowed (example)
Bier lela
Werbung
