Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Entering server address
174 • seca 655/654; seca 455; seca 257/256/254; seca 453
Once the connection has been made, measurement consists of the following
steps:
• Record ID(s) using the barcode scanner; alternatively, if connected directly to
seca analytics 125
: Submit IDs to the device
• Record measured values on the device
• Use the
seca connect 103
System
NOTE
Individual settings for the measurement can be made in the
seca connect 103
settings are agreed during project preparation and set up by seca Ser-
vice.
Device mode
Basic
Advanced
Expert
Service
In order to be able to use network functions, the device must be connected to
one of the following servers - depending on your individual application:
•
, local installation: Local server on which the
seca connect 103
seca connect 103
software is installed.
•
seca connect 103
, cloud installation: Cloud server (you will have received ac-
cess data during project implementation)
•
, cloud installation: Cloud server (you will have received
seca analytics 125
access data during project implementation)
Which of the options mentioned applies to your application will have been
agreed during project preparation.
1. Press the
key.
ð The
menu is displayed.
Settings
2. Press the
or
key until the
3. Press the
item.
Network
4. Press the
Server address
5. Enter the IP address of the server or the server name (DNS):
a) Enter the value
b) Confirm your entry by pressing the
software to transmit measured results to the EMR
software or the
seca analytics 125
Function available
menu item is displayed.
Network
item.
key
software. These
–
–
•
•
Werbung
