Seca 655 Bedienungsanleitung Seite 173

7.4 Setting up network functions
ð The setting is active.
ð Measured results are displayed in the selected system of units.
5. To exit the menu, press the
CAUTION!
Malfunction, implausible measured results
If network settings are not carried out correctly, measured results may
be assigned incorrectly or lost.
► Have the steps described in this section carried out by your admin-
istrator or hospital technician. If you have any questions, contact
seca Service.
NOTE
As soon as the device is connected to a network, the
tion is activated automatically. The
tivated if the device is connected to a network.
The following conditions must be met in order to be able to transmit measured
values to the
seca analytics 125
software (direct connection):
seca analytics 125
• Device is connected to the server for the
• Device is connected to your network via a LAN or WiFi connection
NOTE
In individual cases it may make sense not to connect the device di-
rectly to the
seca analytics 125
seca connect 103
ration.
Third-party EMR System (via
• Device is connected to the server for the
• An interface to the EMR System has been set up in the
software – in agreement with the third-party supplier
• Device is connected to your network via a LAN or WiFi connection
• A barcode scanner is connected to the device
key.
Autohold
software or to a third-party EMR System:
seca analytics 125
software, but rather via the
software. This will be agreed during project prepa-
seca connect 103 ):
seca connect 103
English
func-
Autohold
function cannot be deac-
software
software
seca connect 103
Configuration • 173