Werbung
Verfügbare Sprachen
Verfügbare Sprachen
collection facility. Do no pour it down the drain, on soil
or throw it out with communal waste.
•
ATTENTION
y The user can perform the carburettor purging operation
using the carburettor mud bolt themselves, however,
any work on the carburettor may only be performed by
an authorised service centre for the Heron® brand.
y The air-fuel ratio and the carburettor are set by the manu-
facturer and it is not permitted to make any changes to
these settings. Any amateur tampering with the carburet-
tor settings may result in serious damage to the engine.
FUEL MIXER
y It is forbidden for the user to modify the configurati-
on or to disassemble the fuel mixer (fig. 3, position 2).
Modifying the configuration or tampering with the
mixer may only be performed at an authorised service
centre for the Heron® brand.
MAINTENANCE OF THE EXHAUST
PIPE AND SPARK CATCHER
y Leave the de-carbonisation of the exhaust and cleaning
of the spark catcher to an authorised service centre for
the Heron® brand.
X. Transport and storage
of the generator
y The engine and the exhaust pipe are very hot during
operation and remain hot for a long time after the
generator is turned off, therefore, do not touch them. To
prevent burns during handling and combustion hazards
during storage, allow the generator to cool down before
handling and storing it.
TRANSPORTING THE GENERATOR
y Transport the generator exclusively in a horizontal posi-
tion, suitably secured against movement and impacts in
the transportation area.
y Set the engine shut-off switch to the "OFF" position.
y The fuel supply valve must be closed and the fuel tank
lock must be firmly pulled tight.
y Never start up the generator during transport. Always
take the generator out of the vehicle prior to starting it.
y When transporting it in an enclosed vehicle, always keep
in mind that under strong solar radiation and a higher
EN
ambient temperature inside the vehicle, temperature
will increase extremely and there is a risk of combustion
or explosion of petrol fumes.
y Close the gas outlet from the propane-butane pressure
vessel and secure the vessel for transport so that it can-
not be knocked over or impacted during transport.
BEFORE STORING THE GENERATOR
FOR AN EXTENDED PERIOD OF TIME
y When storing it, ensure that the temperature does not
fall below -15°C or increase over 40°C.
y Protect it against direct sunlight.
y Drain all fuel from the fuel tank and fuel hoses, and
close the fuel valve.
y Purge the carburettor.
y Change the oil.
y Clean the external part of the engine.
y Screw out the spark plug and allow approx. 1 teaspoon
of motor oil to flow into the cylinder, and then pull the
handle of the manual starter 2-3×. This will create an
even protective oil film in the area of the cylinder. Then
screw the spark plug back in.
y Pull on the handle of the manual starter and stop the
piston in the top end position. In this way, the exhaust
and suction valve will remain closed.
y Place the generator into a safe dry room.
y Close the gas outlet on the propane-butane pressure vessel.
XI. Diagnostics
and troubleshooting
potential faults
ENGINE WILL NOT START
y Is the power switch in the "ON" position?
y Is the valve for the supply of the given fuel open?
y Is the choke lever in the "START" position
("CLOSE" – if so designated)?
y Is there sufficient fuel in the tank?
y Is there a sufficient amount of oil in the engine?
y Is the ignition cable connector connected to the
engine's spark plug?
y Is the spark plug generating a spark?
y Do you have old stale petrol in the fuel tank? Add a pet-
rol conditioner to the petrol and stir it in by moving the
108
Werbung
