Scheppach ST570 Originalbetriebsanleitung Seite 39

No current for light or heated
handle (if equipped in this
manner).
No drive.
No or slow ejection of snow.
The ejection shaft does not
engage or does not move.
The machine does not clear
the snow from the surface
correctly.
The ignition cable is loose.
The fuel ventilation is clogged.
The silencer is contaminated or
clogged.
The drive control cable is not firmly
seated.
The drive belt is loose or damaged.
The friction wheel is worn.
The ejector chute is clogged.
Feed screws or wheel drive are
blocked.
The feed screw control cable is not
firmly seated.
The feed screw belt is loose or
damaged.
The shear bolt(s) is(are) sheared.
The throttle is not in the FAST
position during snowblowing.
Movement is too quick to clear the
snow.
Too little snow is blown.
You are trying to clear very
compacted or wet snow.
The feed screw is frozen.
The ejection shaft is not adjusted
correctly for operation.
The shaft is not mounted correctly.
The skids and/or the scraper bar are
not adjusted correctly.
The pressure is the tyres is not
even.
www.scheppach.com
Re-tighten the ignition cable.
Clean or replace the tank cover.
Clean or replace the silencer.
Adjust the drive control cable.
Replace the drive belt.
Replace the friction wheel.
Clean the ejection shaft.
Remove the deposits or foreign objects from
the feed screws or the wheel drive.
Adjust the feed screw control cable.
Replace the feed screw belt.
Fit new shear bolt(s).
Set the throttle to the FAST position.
Put in a lower gear.
Reduce the speed and the clearing width.
Do not overload the machine with very
compacted or wet snow.
Move the unit to a warm location to defrost.
Adjust the ejection shaft operation.
Disassemble the shaft and reassemble it as
described in these instructions.
Adjust the skids and / or the scraper bar.
Check the pressure in one or both tyres and
adjust them.
GB | 39